6 November 2014
In this post, we will connect a USB device to the Edison mini breakout board. If you haven’t set up Edison yet, please go here, then come back to this post.
These are the supplies you will need:
There are four primary ways to supply power to Edison using the Mini breakout board (more info can be found here):
In order to use Edison as a USB host, power must be supplied externally using either J21 or J22. If you supply power with a battery on J2, it will not power the USB connector. So, let’s connect a 9V battery to J21:
Make sure that the red wire is connected to the left pin and the black wire is connected to the right pin (ground). The board lights should now turn on!
Attach the Micro USB OTG to USB adapter to J16 and connect the USB device (I am using a webcam in this example):
Let’s check if the USB device is detected. First, SSH into Edison:
myedison is the name of your Edison.
lsusb at the prompt. This is a Linux command for displaying information about connected USB devices. Hopefully, your console output looks something like this:
root@myedison:~# lsusb Bus 001 Device 002: ID 041e:4095 Creative Technology, Ltd Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
The first line shows that my Creative Cam is detected.
You should be good to go with a lot of USB devices after following these steps. However, you may need to install drivers, as well. For example, if you want to use a webcam, I highly recommend using a UVC-compatible webcam, so that you can use the UVC Linux driver.
To install the UVC driver, type:
opkg install kernel-module-uvcvideo
If the webcam was already plugged into the board, unplug and plug it back in to make sure the webcam is detected properly.
Verify that the webcam is detected by typing
dmesg -c. The console output should look similar to this:
[ 92.910838] hub 2-0:1.0: USB hub found [ 92.910899] hub 2-0:1.0: 1 port detected [ 92.957888] pmic_ccsm pmic_ccsm: USB VBUS Detected. Notifying OTG driver [ 93.210150] usb 1-1: new high-speed USB device number 2 using dwc3-host [ 93.329961] usb 1-1: New USB device found, idVendor=041e, idProduct=4095 [ 93.329992] usb 1-1: New USB device strings: Mfr=3, Product=1, SerialNumber=2 [ 93.330014] usb 1-1: Product: Live! Cam Sync HD VF0770 [ 93.330033] usb 1-1: Manufacturer: Creative Technology Ltd. [ 93.330052] usb 1-1: SerialNumber: 2014090439994 [ 93.339634] uvcvideo: Found UVC 1.00 device Live! Cam Sync HD VF0770 (041e:4095) [ 93.352641] input: Live! Cam Sync HD VF0770 as /devices/pci0000:00/0000:00:11.0/dwc3-host.2/usb1/1-1/1-1:1.0/input/input3
Also, verify that the video device node has been created by typing
ls -l /dev/video0:
root@eejun-edison02:~# ls -l /dev/video0 crw-rw---- 1 root video 81, 0 Nov 10 15:57 /dev/video0
Congratulations! You have now successfully connected a USB device!
Categories: Embeddedcomments powered by Disqus